Dodge TPMS Relearn
CHR-1
1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON position. (engine off)
3. Press and release the MENU button on the EVIC until the message RETRAIN TIRE SENSOR _NO is displayed.
4. Press the STEP button to select YES.
5. Press the MENU button to start the relearn process. The EVIC will display the message, TRAIN LEFT FRONT TIRE.
6. Starting at LF tire, place relearn magnet over valve stem until horn sounds.
7. After horn sounds, proceed as in step 5 for the next 3 sensors in this order: RF, RR, LR, SP (if equpped).
8. Once the EVIC displays the message TRAINING COMPLETE, depress the STEP, C/T, RESET, or MENU buttons to exit the relearn procedure.
CHR-2
Ensure all tires are inflated to the pressure listed on the tire placard. When ignition is turned off, the system will be cleared and the TPMS telltale will turn off. The system will recalibrate when vehicle is operated at a speed of 30 mph for a minimum of 30 seconds.
CHR-3
1. Inflate all tires to pressure indicated on tire placard.
2. Turn ignition to ON position. (engine off)
3. Press and release the MENU button on the overhead console until the message RETRAIN TIRE SENSOR-NO is displayed.
4. Press the STEP button to select YES.
5. Press the MENU button to start the relearn process. The EVIC will display the message, TRAIN LEFT FRONT TIRE.
6. Starting at LF tire, place relearn magnet over valve stem until horm sounds.
7. After horn sounds, proceed as in step 5 for the next 3 sensors in this order: RF, RR, LR, SP (if equipped).
8. Once the EVIC displays the message TRAINING COMPLETE, depress the STEP, C/T, RESET, or MENU buttons to exit the relearn procedure.
CHR-4
Relearn can be completed using a properly formatted scan tool and relearn magnet.
*Relearn magnet not required for Prowler.
Chrysler TPMS Reset - Relearn
|
|
Dodge TPMS Reset - Relearn
|
|
|
